What It Costs to Insulate a House in Boulder City, NV
Insulating a whole house in Boulder City usually runs $2,400 to $7,800 for attic and crawl space work, and $4,100 to $12,500 once walls are included. The honest number depends on which of three construction eras your home belongs to, because a 1930s Boulder Home has no wall cavity to fill while a post-1990 infill house does. Call (844) 320-7926 for a written price before any work starts, broken out by zone and backed by a blower-door reading that tells you where the money should actually go.

Boulder City sits in a climate that punishes an under-insulated envelope from both directions. July afternoons push past 110°F with brutal solar gain on the roof, and winter nights drop near freezing. That dual load is why a real insulation plan here has to solve two separate problems: rejecting radiant heat at the attic plane and holding thermal resistance in the assembly below it. Those are two line items with two different paybacks.
Which Kind of Boulder City House Do You Have?
The core of Boulder City is the federally built Boulder Homes from the 1930s and ’40s, small single-story houses constructed for dam workers. Many have solid masonry or single-board walls with no cavity at all, and attic spaces that hit 150°F in July. When our technicians open a wall in one of these homes, the only insulation they sometimes find is 1930s newspaper or horsehair. That’s not a curiosity. It’s a structural constraint that changes what you can buy.
Outside that historic core, the rest of Boulder City splits into mid-century ranch housing and newer infill. Each era gets a different scope, and pretending they’re the same is how homeowners end up paying for insulation that doesn’t perform.
Tier 1: 1930s-40s Boulder Homes (masonry, no wall cavity)
You can’t dense-pack a solid masonry wall without furring out the interior, which turns an insulation job into a renovation. So the budget here anchors on the attic: air sealing the top plates and penetrations first, then blown-in insulation to the max the joists will carry. A radiant barrier earns its place in these homes because the attic roofline takes the full desert sun. Expect $2,400 to $5,200 for the attic scope plus radiant barrier, and treat wall insulation as a separate renovation conversation, not a line in this estimate.
Tier 2: Mid-century ranch (2×4 frame, possibly already batts)
Framed walls open the door to dense-pack cellulose if the cavities are empty, which we confirm with a quick inspection rather than a guess. Attic work plus wall dense-pack typically lands $4,100 to $9,800 depending on square footage and how many walls are actually hollow. GreenFiber cellulose is a common choice here for its cost per R-value.
Tier 3: Post-1990 infill (open-web truss, modern access)
Newer construction is the easiest to bring up to a high performance target. Open access makes air sealing straightforward and blown-in fiberglass or mineral wool drops in cleanly. Figure $3,200 to $6,600 for a complete attic upgrade with air sealing, and add walls only if the existing batts have settled or were skipped.
The Blower-Door Test Is a Line Item, Not a Freebie

Here’s what a lot of quotes skip: the blower-door test. It’s a pressurization reading that shows, in a single number, how much air your building envelope is losing. Measured in ACH50 (air changes per hour at 50 pascals), it tells you whether your money belongs in air sealing, in added R-value, or in the crawl space. Without that measurement, a whole-house number is allocated by assumption.
We charge for it and we show you the numbers. A typical Boulder City pre-work reading on an unsealed 1930s attic floor might come back around 12 to 14 ACH50; after sealing and insulating, we regularly see that drop toward 5 to 7. Those before-and-after figures are published on every applicable job, so you can compare your result against houses built in the same era and the same climate, not a national average from a different decade.
- Blower-door test (pre and post): $250 to $450 per test, both readings included in the scope
- Attic air sealing: top plates, can lights, plumbing and electrical penetrations
- Attic insulation: blown-in fiberglass, cellulose, or mineral wool to target R-value
- Radiant barrier: separate line item with its own payback, not bundled into R-value
- Crawl space encapsulation and vapor barrier: only when the reading shows it matters
Boulder City Whole-House Insulation Price Ranges
These are the ranges we quote most often in Boulder City. Yours gets firmed up after we walk the house and take a reading.
| Line item | Typical range |
|---|---|
| Blower-door test (before and after) | $250 - $450 |
| Attic air sealing | $450 - $1,100 |
| Attic blown-in insulation (Tier 1 Boulder Home) | $1,600 - $3,400 |
| Attic blown-in insulation (Tier 2 or 3) | $1,800 - $4,200 |
| Wall dense-pack (framed walls only) | $1,700 - $4,400 |
| Radiant barrier installation | $650 - $1,800 |
| Crawl space encapsulation and vapor barrier | $1,900 - $5,200 |
| Whole-house total, attic + walls | $4,100 - $12,500 |
The written price you get is broken out by zone rather than delivered as one lump sum. That’s deliberate. It lets you phase the project in the priority order the blower-door data identifies, so if the attic sealing shows the biggest air loss, you fix that first and schedule the crawl space later without renegotiating the whole job. Haven Standard Clause 1 is flat price, written scope, written warranty before anyone lifts a tool.
Sealed First, Then Insulated: Why the Order Matters

Blowing insulation over an unsealed attic floor is the most common insulation mistake we correct in Boulder City. Air moves through the gaps you didn’t seal, so the added R-value never performs the way the label says. We air seal first and insulate second, in that order, every time. It’s not an upsell tacked onto the estimate; it’s the prerequisite that makes the rest of the work valid.
Every job closes with a Documented Photo Record, so you see the sealing before it disappears under insulation. Our technicians have up to 10 years of experience reading these houses, and the documentation is what you keep. The 365-Day Done Right Promise backs every completed job: if it isn’t done right, we make it right. Because Boulder City homes have been sealed and insulated by us as part of 9,000+ completed since 2016, the records add up to a real performance benchmark for this housing stock.
For a closer look at the full scope of what we install, see our Insulation Installation in Boulder City page, or start from our home page to review the whole building-envelope service line.
FAQs
Most whole-house attic and crawl space jobs in Boulder City run $2,400 to $7,800, and full attic-plus-wall projects run $4,100 to $12,500. The range swings on which construction era your home falls into and whether your walls have a cavity to fill. Call (844) 320-7926 for an exact written quote, broken out by zone, before any work begins.
Yes, if you want to spend your budget where it actually performs. The blower-door test measures how much air your envelope loses in a single figure, so the plan targets the real leaks instead of a guess. We include before-and-after readings so you can verify the improvement. Call (844) 320-7926 to schedule a test and written estimate.
We can improve the envelope substantially through the attic, but a solid masonry wall has no cavity to fill without furring out the interior. For these homes we air seal and insulate the attic and add a radiant barrier, then discuss wall options as a separate renovation. Call (844) 320-7926 and we’ll walk you through what’s realistic for your specific house.
Often yes, especially on 1930s-’40s homes where the roofline takes full desert sun and attic temps hit 150°F. A radiant barrier rejects solar heat before it enters the assembly, which is a different job than R-value and carries its own payback. We quote it as its own line so you can see the numbers. Call (844) 320-7926 for a written price.
Get Your Written Price Before Any Work Starts

Every Envelope Insulation Boulder City job begins with a flat written price and written scope, then closes with a Documented Photo Record and before-and-after blower-door numbers on applicable work. Materials come from Owens Corning, GreenFiber, and Icynene, among others, with no proprietary lock-in. Call (844) 320-7926 for a free estimate and a plan built around your home’s actual construction era.
Written by the team at Envelope Insulation Boulder City, serving Boulder City, NV.
What Our Customers Say
"They air-sealed the attic floor before insulating and showed me the blower-door number before and after. The upstairs is finally the same temperature as downstairs."
- Marisol D."The winter gas bill dropped by about a third. They had estimated a quarter, so they under-promised."
- Genevieve R."Crawl space encapsulation done properly. Photographs of the vapour barrier at every seam, and the damp smell in the hallway is gone."
- Ainsley P.