Trusted Radiant Barrier Installation for Boulder City Homeowners
If your Boulder City attic turns into a 140-degree oven by mid-June, you already know the air conditioner runs all afternoon and still loses ground. A radiant barrier changes the physics: a reflective layer that bounces radiant heat back off the roof deck before it ever reaches the insulation, so the AC isn’t fighting the sun all day. Attic temperatures in Boulder City can run 30 to 40 degrees above the outside air on a clear summer afternoon, and a properly installed barrier knocks the roof-deck radiant load down substantially. Our technicians have up to 10 years of experience, and we publish before-and-after blower-door numbers on the jobs where air sealing is part of the scope.

Same-day and next-day scheduling is often available in Boulder City, and a live person answers the phone around the clock. Call (844) 320-7926 to get a written price before any work starts.
One thing we won’t do: blow insulation or install a barrier over an unsealed attic floor. Sealed first, then insulated, then reflective. That order is the whole job. Air sealing of top plates, can lights, and penetrations comes before any material goes down, because a radiant barrier over a leaky attic just reflects heat into a space that’s still losing conditioned air.
What Our Radiant Barrier Installation Service Includes
Radiant barrier isn’t one product; it’s a family of approaches that depend on your roof assembly, your venting, and whether your priority is blocking roof-deck heat or reflecting it back off a flat attic floor. Here’s how we break it down for Boulder City homes.
Attic Radiant Barrier
An attic radiant barrier is a reflective sheet, usually foil-faced, laid across the attic floor joists or stapled under the roof, that stops radiant heat from radiating down into the living space. You need it when the upstairs rooms are noticeably hotter than the downstairs even after the AC has run for hours. In Boulder City we see this most in slab-on-grade homes built through the 1990s and 2000s, where the attic insulation has settled and the deck gets full afternoon sun. We measure the existing attic conditions, seal the air pathways first, then install the barrier so it doesn’t trap moisture or block the soffit path.
Radiant Barrier Foil
Radiant barrier foil is the perforated, reinforced aluminum product that goes on the underside of the roof rafters or over the attic floor. You need it when you want the highest reflectivity per square foot and a product that will hold up to attic humidity without delaminating. The perforations matter in our climate: they let moisture pass so you don’t create a condensation trap against the roof sheathing. We spec foil from Owens Corning or Johns Manville, and we tape seams and seal edges so the reflective coverage is continuous rather than a patchwork.
Radiant Barrier Roof Deck
A roof-deck radiant barrier is applied directly to the underside of the roof sheathing, often as a foil-faced OSB or a stapled radiant sheet, and it attacks the heat at the source before the attic air absorbs it. You need it when the attic is a usable or semi-usable space, or when the roof pitch and venting make a floor-mounted barrier impractical. On Boulder City tile and shingle roofs, roof-deck installs demand careful attention to the ridge and soffit vent path so the barrier doesn’t choke the convection that carries heat out. We map the venting before we cut the first panel.
Radiant Barrier & Ventilation
Radiant barrier and ventilation work as a pair: the barrier reflects radiant heat, and the venting carries the remaining hot air out of the attic. You need the combination when the attic is under-vented, which traps heat regardless of how reflective the product is. In Boulder City we check the net free vent area against the attic square footage, add ridge or soffit venting where the numbers fall short, and balance intake to exhaust. Installing a barrier over a choked attic is money spent on the wrong half of the problem.
If your attic also needs new thermal insulation, we handle attic insulation in the same visit so you’re not paying for a second mobilization.
Brands We Service for Radiant Barrier Installation

We source reflective and insulation materials from Owens Corning and Johns Manville, two brands whose radiant foil and facing products we’ve worked with across thousands of Boulder City attics. We know how each product handles our summer heat cycling, where the facing tends to wrinkle, and which seam tapes hold under thermal expansion. When a homeowner has a specific product in mind, we’ll read the spec sheet with you and tell you plainly whether it’s the right call for your roof assembly.
We also work with Knauf and Rockwool on the insulation side of any job where the attic floor needs topping up after the barrier goes in. The materials come from the manufacturer, not from a proprietary system, so there’s no lock-in and no reason to push one product over another. Whether your attic calls for Owens Corning, Johns Manville, Knauf, Rockwool, or any other make, we can help.
Signs You Need Radiant Barrier Installation Right Now
- Upstairs rooms run 5 – 8 degrees hotter than downstairs. That gap is the signature of radiant heat loading through the roof deck. It’s the most common reason Boulder City homeowners call us, and it shows up worst on west- and south-facing rooms in late afternoon.
- The AC runs steady from noon to sundown without cycling off. A unit that can’t satisfy the thermostat in summer is often working against radiant gain the insulation alone can’t stop. A barrier reduces what the AC has to remove.
- Attic air hits 140°F or higher on a summer afternoon. If you’ve stuck a thermometer up there and watched the needle climb past 130, the roof deck is radiating heat down into the living space. The hotter the attic, the more a barrier pays back.
- You’ve just had insulation installed and the attic is still hot. Insulation slows conductive heat but does little against radiant heat. If new insulation didn’t fix the comfort gap, the missing layer is likely reflective, and the air sealing should be verified before anything else goes down.
- Your energy bill spikes every July and August. Seasonal peaks that track the sun rather than the calendar point to radiant load. We compare the pattern against your attic conditions before recommending a fix, so you’re not buying the wrong product.
Our Radiant Barrier Installation Process – Step by Step

- 1
Attic assessment and measurements. We go up, measure the attic square footage, map the venting, and check the existing insulation depth and any moisture staining. We photograph what we find so you see the same conditions we do.
- 2
Air sealing before anything else. Top plates, can lights, plumbing and wiring penetrations, and the attic hatch get sealed first. On jobs where a blower-door test applies, we take a baseline reading – a pressurization measurement that shows, in one number, how much air the envelope is losing – before the barrier goes down.
- 3
Written price and scope. Before any material is cut, you get a flat written price, a written scope, and a written warranty. Haven Standard Clause 1 is simple: have it in writing. No work starts without it.
- 4
Barrier installation. We install the barrier in the configuration the attic calls for – floor-mounted foil, roof-deck panels, or a combination – taping seams and protecting the vent path as we go. The install takes one to two days depending on attic size and access.
- 5
Final verification and photo record. We re-check the venting and, where air sealing was part of the scope, take a post-work blower-door reading so you can see the change in a single figure. You walk away with the documented photo record of the finished job.
If the attic also needs air sealing as a standalone scope, that lives under attic air sealing, and we’ll fold it into the same visit when it makes sense.

How Much Does Radiant Barrier Installation Cost in Boulder City?
Most attic radiant barrier jobs in Boulder City run between $1,200 and $3,200 depending on attic size, the configuration, and whether air sealing or new insulation is part of the scope. A basic foil-over-floor install in a 1,500-square-foot ranch house typically lands near the low end; a roof-deck install with added ridge venting on a larger two-story pushes toward the top. If you’re pairing the barrier with insulation, add $1,800 to $4,500 for blown-in material, and factor in a small premium if the attic has limited access.
What moves the price: attic square footage, roof pitch and access, whether you need new venting, whether the barrier goes on the floor or the deck, and whether air sealing is part of the same visit. What to watch for: a quote that installs the barrier before sealing air leaks, or one that skips the venting check. Either shortcut leaves you with a reflective surface doing half its job.
The way to avoid overpaying is to get the written scope side by side with any competing quote. Under Haven Standard, we offer a free second opinion on any written estimate and will read it with you. Your written price before any work starts is the whole point of Clause 1, so there’s nothing to negotiate after the fact. If the work isn’t done right, the 365-Day Done Right Promise applies.
Radiant Barrier Installation Near Boulder City – Our Service Area

We install radiant barriers across Boulder City and the surrounding valley, including Radiant Barrier Installation in Henderson and Radiant Barrier Installation in Whitney, along with Paradise, Enterprise, Winchester, Sunrise Manor, Spring Valley, Summerlin, North Las Vegas, and Las Vegas. Response to Henderson and Whitney is typically same-day or next-day, and the wider metro runs within a day or two of your call. Call (844) 320-7926 for scheduling.
Serving Boulder City, NV – Our Local Coverage Area
We serve Boulder City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Radiant Barrier Installation in Boulder City

Radiant barrier installation is the process of adding a reflective layer to your attic – on the floor, under the roof rafters, or on the roof deck – that reduces the amount of radiant heat the roof deck sends down into the living space. It’s not the same as insulation, which slows conductive heat; the barrier reflects radiant heat, and the two work best together. In Boulder City, where attic air regularly climbs past 130 degrees in summer, the barrier is the layer most homes are missing.
Most residential radiant barrier installations take one to two days for the barrier itself, and a day or two more if air sealing and insulation are part of the same scope. A smaller attic with floor-mounted foil can finish in a single day. We give you the timeline in the written scope before anyone starts, so you know what the week looks like. Call (844) 320-7926 and we’ll tell you what to expect for your attic.
Most jobs run between $1,200 and $3,200, with the low end for a floor-mounted foil install in a smaller ranch and the high end for roof-deck work with added venting on a larger home. Pairing the barrier with insulation adds roughly $1,800 to $4,500. Call (844) 320-7926 for an exact written price – estimates are free, and the free second opinion reads any competing quote with you.
Yes. We work with Owens Corning and Johns Manville radiant foil and know how each product performs under Boulder City’s summer heat cycling. We’ll read the product spec against your roof assembly and tell you which one fits rather than pushing a single make. Call (844) 320-7926 to talk through materials for your attic.
Same-day and next-day scheduling is often available in Boulder City, and a live person answers calls around the clock so you can reach us any time. Radiant barrier is usually planned work rather than an emergency, but if a failed install or a sudden comfort problem has you stuck, call and we’ll tell you honestly how soon we can be there. Call (844) 320-7926.
Every completed job falls under the 365-Day Done Right Promise: if it isn’t done right, we make it right. You also get the written warranty and written scope before anyone lifts a tool, and the documented photo record when the crew leaves. Nothing verbal, nothing implied. Call (844) 320-7926 to see the written terms before you commit.
You don’t need to do much. Clear attic access so the crew can get in and out without moving stored items, and move anything fragile or valuable out of the attic path beforehand. We seal and protect the working area and clean up when we leave. If your attic is cluttered, tell us on the call and we’ll plan for it – call (844) 320-7926.
Schedule Your Radiant Barrier Installation Service in Boulder City Today
Get the attic cool and the AC bill back under control. Call (844) 320-7926 for a free estimate and a written price before any work starts. Our technicians have up to 10 years of experience, the 365-Day Done Right Promise backs the work, and a live person answers around the clock. No obligation, no pressure – just the price and the plan in writing.
Written by the team at Envelope Insulation Co.