Knauf Attic Insulation: The Boulder City Owner’s Guide
If your attic insulation has settled, gone soft, or started reading wet at the joists, we install Knauf insulation systems in Boulder City, and most blown-in attic jobs on a 1,200 – 2,200 sq ft house run between $2,400 and $5,800 installed, with air sealing included before a single bag goes up. Knauf Ecobatt and Knauf Jet Stream (blown fiberglass) are the two products we specify most here. We can often schedule same-day inspections, and a live person answers at (844) 320-7926 any hour.
Owners in Boulder City rarely notice insulation until something else forces them into the attic: the summer power bill climbs into the $300s, a bedroom above the garage won’t cool below 80°F, or a roofer finds damp fiberglass matted around a can light. Knauf fiberglass doesn’t fail suddenly. It loses R-value slowly as it settles and takes on desert dust and monsoon moisture. By the time it’s visible, the number on your utility bill has usually been telling the story for two summers.
Key Takeaways
- We install Knauf Ecobatt and Jet Stream in Boulder City attics, sealed first, insulated second, never the other way around.
- Most installed jobs here run $2,400 – $5,800. Price depends on existing R-value, square footage, and how much air sealing the attic floor needs.
- Knauf fiberglass in a Nevada attic typically holds usable R-value for 15 – 20 years if it stays dry. Heat cycling and monsoon leaks shorten that.
- Every job gets a written price before work starts and before-and-after blower-door readings so you can see the leakage number that changed.
- You get a Documented Photo Record when we leave, not on request.
Which Knauf Models This Applies To

Knauf’s residential attic lineup runs in a few distinct product families, and knowing which one is in your attic tells us how to match or replace it. The two you will actually see in Boulder City homes are Knauf Ecobatt (kraft-faced or unfaced fiberglass batts, sold in R-13 up to R-38 thicknesses, sized for standard 16″ and 24″ on-center framing) and Knauf Jet Stream (blown-in loose fiberglass, bagged, with a listed settled R-value per inch that runs roughly R-2.2 to R-2.5 depending on density and the blowing machine’s calibration). Older installs sometimes carry Knauf’s prior-generation loose fill under a discontinued bag label.
To identify what is up there, look for the bag label stapled to a truss (contractors leave one on purpose), or measure the settled depth with a tape at three points and note the framing spacing. A batt at 5.5″ of settled depth is not the same product as loose fill at the same depth, and treating them as interchangeable is the most common estimating error we correct on second opinions.
On the OEM-versus-aftermarket question: for Knauf, this is less about a “genuine part” and more about the settled-R-value and density spec. A competing brand of loose fiberglass blown to the same settled density and the same listed R-value will perform the same in your attic, and we source from Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, and GreenFiber without a proprietary lock. What matters is that the bag label matches the target R-value for Boulder City’s climate zone (we target R-49 to R-60 here, driven by our 100°F-plus summers), and that the installer documents the bag count and settled depth. Envelope Insulation Boulder City is an independent service provider, not affiliated with Knauf, so we have no reason to steer you toward a brand that doesn’t fit.
One compatibility gotcha worth naming: if your attic has recessed can lights rated “IC” (insulation contact), blown fiberglass can be blown directly over them. If the cans are non-IC, or if the baffle has been removed and not replaced, the insulation has to be dammed away, not blown over. We’ve opened Boulder City attics where a prior crew blew over non-IC cans and the fiberglass was scorched brown within a foot of the housing. The insulation didn’t fail. The installation did.
Signs Your Knauf Attic Insulation Is Failing
- Settled depth is 30% or more below the bag label’s stated R-value. Loose fiberglass in Boulder City attics loses thickness over 10 – 15 years under its own weight and thermal cycling. When Jet Stream settles from an R-49 target to an effective R-30, the insulation still looks present but is no longer doing the job.
- Damp or clumped fiberglass, especially near can lights or plumbing penetrations. Knauf fiberglass that has taken moisture from a monsoon roof leak, an AC condensate line, or a bathroom exhaust that terminates into the attic will clump and lose R-value permanently. Damp insulation needs to come out, not be topped up.
- Dust-darkened batts with visible fiber matting. Fiberglass filters attic air over time, and the dust load gives the batts a grey tint and reduces their effective R-value. This is why we route bathroom exhaust to the roof deck, not into the attic.
- Drafty rooms above the garage or at the exterior walls, even after insulation was replaced. The insulation is fine. The attic floor is not sealed. Top plates, penetrations, and rim joists leak conditioned air into the attic regardless of how much insulation sits on top.
- The pipe chase and top plates show gaps you can see from the attic floor. Visible daylight around a plumbing vent or electrical chase means air is moving through that opening at every temperature swing. This is the symptom that makes a “new insulation” job underperform, and it’s the one we fix first.
Replacement Cost & What’s Included

Here is what a Boulder City attic insulation job looks like on a written price. The parts-plus-labor transparency is the point: you can see what the insulation costs and what the air sealing costs, and you can see what each line item buys you.
| Line item | Typical installed range |
|---|---|
| Blown-in Knauf Jet Stream, R-49 to R-60, up to 2,000 sq ft | $1,800 – $3,900 |
| Attic air sealing (top plates, penetrations, can light dams) | $700 – $1,600 |
| Knauf Ecobatt batt install, per 1,000 sq ft of attic floor | $900 – $2,000 |
| Old insulation removal and disposal (if damp, contaminated, or compacted) | $600 – $1,400 |
| Before-and-after blower-door test | Included on every applicable job |
What pushes a Boulder City job toward the top of that range: existing insulation that has to come out, a long attic run that limits hose reach, non-IC can lights needing dams, and high ceiling heights in the vaulted sections. Under Haven Standard: Clause 1, you get a flat written price, a written scope, and a written warranty before anyone lifts a tool. The 365-Day Done Right Promise covers the work for a full year, and if we missed something, we come back and make it right.
One honest note: attic insulation is not a DIY-dangerous product the way garage door springs or electrical panels are. Knauf fiberglass needs gloves, eye protection, and a respirator, and a hot Boulder City attic in July is a heat-illness hazard. The dangerous part of this job isn’t the material. It’s the ladder, the narrow walkways between joists, the can light wiring you can’t see under the existing fill, and the combustibles buried in it. That’s the paragraph we want you to read before anything else.
DIY or Call Us?
An owner can safely do three checks. Measure settled depth at several points with a tape. Note the bag label if you find one. Look for daylight around penetrations without moving insulation. That small amount of information is enough to get an accurate phone estimate, and it doesn’t put you on a ladder.
What we would not advise a homeowner to do is blow new fiberglass over an unsealed attic floor, dam non-IC can lights, or crawl through a Boulder City attic in summer heat with loose fill you may not realize is damp. The insulation going on top of unsealed leaks is the single most common failure we correct, and the cost to redo it is far higher than doing it right the first time. If you’re unsure after your inspection, call (844) 320-7926 and we’ll talk through what you found. If you’re already in the market, we give a free second opinion on any written estimate you’ve received, which is often the fastest way to find out whether the quote you’re holding is fair.
FAQs

How long does Knauf attic insulation last in Boulder City? Knauf Ecobatt and Jet Stream hold usable R-value for 15 – 20 years in an attic that stays dry, but Boulder City’s summer heat cycling and monsoon intrusion shorten that. Plan on inspecting every 5 years and replacing when settled depth drops 30% or more below the label’s stated R-value. Call (844) 320-7926 for an inspection and a written price.
Can I top up my existing Knauf insulation instead of replacing it? Yes, if the existing insulation is dry, uncompressed, and doesn’t have visible moisture or rodent contamination. Topping up Jet Stream over sound Jet Stream is a legitimate repair. The catch: topping up over an unsealed attic floor wastes the new insulation. We seal first, then top up.
How long does a Knauf attic insulation job take? Most Boulder City houses run a single day for a 1,500 – 2,000 sq ft attic if the old fill doesn’t need removal, and two days when it does. Air sealing plus blown-in is typically a six-to-eight-hour day with two technicians. The blower-door test before and after adds roughly 90 minutes.
How do you source the Knauf insulation for my Boulder City job? We source from regional suppliers who carry Knauf, Owens Corning, Johns Manville, Rockwool, CertainTeed, and GreenFiber, and we spec the brand that matches your target R-value and existing product family. Envelope Insulation Boulder City is independently owned and operated, not a Knauf dealer, and we don’t lock you into one brand. What we do under The Haven Standard: write the price down, document the settled depth and bag count in the photo record, and publish the before-and-after blower-door numbers so you can see what changed.
If your attic is in the failing-soft category and you want a real number instead of a phone estimate, call (844) 320-7926 for a free estimate. We’ll inspect the attic, measure existing depth, and leave you with a written price and scope before anyone touches a bag.
Written by the team at Envelope Insulation Boulder City, serving Boulder City and nearby areas.