Demilec Radiant Barrier Installation: The Boulder City Owner’s Guide
We install Demilec-compatible radiant barrier systems in Boulder City, and most residential attic radiant barrier jobs run between $1,650 and $3,400 installed, depending on attic square footage, roof pitch, and whether the foil needs to go over an existing deck or a fresh sheathing run. Radiant barrier is a straightforward install compared to roof or air-sealing work, so scheduling is usually within a few days, not weeks. Most Boulder City owners discover the barrier has failed the same way: summer attic temperatures climb past 140°F, the second-floor rooms won’t cool below 78°F no matter where the thermostat sits, and the utility bill jumped $60 to $100 a month against the same season last year. When they climb into the attic, the foil is wrinkled, torn at the seams, or coated in dust that has turned it matte gray.
Which Demilec Models This Applies To
Demilec radiant barrier products show up under the Heatlok and Sealection family of spray foam systems, but the radiant barrier itself is usually a separate foil product specified alongside the foam. The Demilec-labeled barrier film we install most often in Boulder City is the reinforced aluminum foil facing rated for attic deck and rafter applications, and it’s identified by the Demilec logo printed on the foil edge along with a lot number and a stated emissivity of 0.03 to 0.05. If the label is gone, measure the foil roll width (typically 48 inches) and check the perforation pattern: Demilec-compatible attic foil is micro-perforated to allow moisture vapor to pass, and a non-perforated foil in a Boulder City attic will trap condensation against the roof deck and cause sheathing rot within a few seasons.
The OEM-versus-aftermarket decision matters here. Demilec-branded foil is the exact-match option and carries the manufacturer’s stated emissivity rating. Quality aftermarket equivalents from suppliers like Reflectix meet or exceed the same emissivity spec and are widely accepted in Boulder City attic retrofits. What we won’t do is install a non-perforated or thin-gauge foil under a Demilec label; the failure rate in southern Nevada heat is too high. We are an independent service provider and are not affiliated with Demilec.
Signs Your Demilec Radiant Barrier Installation Is Failing

Radiant barrier fails slowly, so the symptoms usually show up as a stack of small changes rather than one dramatic event. Here’s what we look for on a Boulder City attic inspection:
- Attic temps above 140°F on a 105°F day. A working barrier keeps the attic within 20 to 30°F of outdoor air. When the gap widens, the foil has lost reflectivity or peeled away from the deck.
- Foil lifting or sagging between rafters. Adhesive-backed foil in Boulder City attics loses grip as the roof deck cycles through 40°F mornings and 150°F afternoons. Once it sags, it stops reflecting and starts trapping heat against the drywall below.
- Visible tears at seams and penetrations. Every cut for a can light, exhaust fan, or plumbing vent is a place where the foil edge can curl. A tear the size of a playing card is enough to let radiant heat pour through.
- Dust film on the foil surface. Aluminum foil that has turned from shiny to matte gray is no longer reflecting. Dust buildup drops emissivity performance by 30 to 50 percent, and it can’t be cleaned in place once it’s baked on.
- Condensation stains or dark streaks on the roof deck. This is the perforation failure. Non-perforated foil in a Boulder City climate traps moisture against the sheathing, and the streaks are the first sign the barrier is doing more harm than good.
Replacement Cost & What’s Included
Most radiant barrier replacements in Boulder City fall in the $1,650 to $3,400 range. The low end covers a simple gable attic in the 1,000 to 1,400 square foot range with clean deck access and no existing foil to remove. The high end covers 2,200 to 2,800 square feet, steep pitch, foil removal, and re-sealing around penetrations before the new barrier goes down. Line items we quote:
- Foil material (Demilec-compatible or Reflectix equivalent): $0.35 to $0.65 per square foot
- Removal and disposal of old foil: $180 to $400
- Labor and installation: $0.45 to $0.80 per square foot
- Penetration sealing and edge taping: $120 to $260
You get a written price before any work starts, and the 365-Day Done Right Promise covers the installation. A Documented Photo Record of the finished barrier goes with every job so you can see what was installed without climbing into the attic yourself.
DIY or Call Us?

You can safely check a few things yourself: measure the attic square footage, look at the foil surface for tears or dust, and read the label on the foil edge. What we wouldn’t recommend is climbing around a Boulder City attic in July, walking joists with a staple gun, and installing foil over a deck that may have live can lights or exhaust ductwork nearby. The heat alone sends people to the ER every summer, and a barrier installed wrong (non-perforated, stapled loose, or covering recessed fixtures) causes moisture damage or a fire hazard that costs more than the original job. Call us at (844) 320-7926 and we’ll give you a free second opinion on any written estimate you already have.
FAQs
Ten to fifteen years is realistic for a properly installed perforated foil in southern Nevada, though the outer edges of the barrier facing direct sun exposure often degrade closer to eight years. Attic heat and UV leak-through are the main killers. Call (844) 320-7926 if you’re near that range and want an inspection before next summer.
Small tears and lifted seams can be repaired if the foil still has reflectivity and the perforations are intact. Once dust has baked on or the foil has sagged in more than a few sections, repair is throwing good money at bad material. Call us at (844) 320-7926 and we’ll tell you which side of that line you’re on.
Most Boulder City radiant barrier replacements run one to two working days, with the second day reserved for larger attics or removal of an old foil layer. You’ll get a text when the technician is on the way, and the price doesn’t move once the work starts.
We order the Demilec-compatible foil through standard building material distribution and can match it to a Reflectix equivalent if the Demilec line is out of stock. You’ll see the part specification on your written scope before anything is ordered. Call (844) 320-7926 for a free estimate.
If your Boulder City attic is running hotter than it should and the foil up there looks tired, call Envelope Insulation Boulder City at (844) 320-7926 for a free estimate. You’ll get a written price before any work starts, a free second opinion on any written estimate you already have, and a Documented Photo Record when the job is done.
Written by the team at Envelope Insulation Boulder City, serving Boulder City and nearby areas.