CertainTeed Spray Foam Insulation in Boulder City: What to Know First
We provide independent CertainTeed spray foam insulation work in Boulder City, and most residential jobs here run one to two days from air sealing through final blower-door reading. Prices are written before any work starts: open-cell attic and wall jobs typically land between $1,800 and $4,200 depending on square footage and depth, and closed-cell rim joist or roof deck work runs higher per board foot. This page is for Boulder City homeowners who already have CertainTeed products in the envelope – membrane, sheathing, or spray foam – and need the spray foam side assessed, extended, or replaced. Call (844) 320-7926 and a live person answers, day or night.
How CertainTeed Products Fail – and How We Fix Them
CertainTeed makes several product families that show up in Boulder City attics and rim joist assemblies, and each fails differently once the desert climate gets to work on it. Here is what our technicians actually find, and what the fix looks like.
- MemBrain smart vapor retarder with taped seams pulling loose at the top plate. MemBrain is a variable-permeability membrane, and it works only if the perimeter seal holds. In Boulder City’s summer attic heat, the tape adhesive on vertical seams dries and lifts, which lets humid interior air bypass the membrane and condense on the cold sheathing behind it. Our fix: strip the failed tape, re-seal the top plate and penetrations with closed-cell foam, then re-tape the membrane to the framing rather than to itself.
- CertainTeed NOVA or Sustainable Insulation fiberglass batts compressed by blown-in spray foam added over the top. We regularly find batts crushed to two-thirds their rated thickness where a previous installer foamed over the joists without lifting or removing them. Compressed fiberglass loses its R-value fast, so the assembly reads R-13 when the label says R-19. Our fix: remove the compressed batts, air seal the floor, then apply open-cell foam at the correct depth directly against the deck.
- Closed-cell spray foam applied directly over CertainTeed sheathing that was never verified dry. Foam over damp substrate traps moisture against the sheathing and can delaminate the bond line within two seasons. This is a real failure we find in Boulder City after monsoon-season leaks. Our fix: moisture readings on every bay before we spray, and any bay above the threshold gets dried and documented before foam goes down.
- Fiber cement soffit and fascia joints opening along the roof-line penetration. CertainTeed fiber cement siding at the soffit is dimensionally stable, but the penetrations through it – vent stacks, cable runs, bath fan terminations – are where heated attic air escapes. Our fix: foam those penetrations from the inside before we add any attic insulation, part of the sealed-first rule we never break.
- Recycled-content fiberglass losing its binder and sagging away from the rim joist. CertainTeed Sustainable Insulation uses recycled glass content, and in a Boulder City garage or cantilevered floor, years of 100-degree-plus attic cycling cause the binder to give up and the batt to sag off the band joist. Our fix: the rim joist gets closed-cell foam, two inches minimum, and the sagging batt goes to the dumpster.
Our CertainTeed Spray Foam Insulation Process

Every CertainTeed spray foam job we run follows the same sequence, whether it is a single rim joist or a full roof deck. No step gets skipped because a crew is in a hurry.
- 1
Diagnostic visit. We walk the assembly, take moisture readings, and run a blower-door test – a pressurization measurement that shows, in one number, how much conditioned air the envelope is losing. You get the reading before we touch anything.
- 2
Written price and scope. Flat price, written scope, written warranty, delivered before work is scheduled. Haven Standard Clause 1: have it in writing.
- 3
Air sealing first. Top plates, can lights, and every penetration get sealed before any insulation goes in. We will not blow or spray insulation over an unsealed floor.
- 4
Foam application. Open-cell, closed-cell, or a combination chosen by assembly, not by what is easiest to sell. CertainTeed products already in the envelope are assessed for reuse versus removal, and we document which and why.
- 5
Post-work blower-door test. Second reading, compared against the first, published on the job record so you can see what you paid for in CFM50.
- 6
Documented Photo Record and cleanup. Photos of sealed penetrations, foam depth, and the blower-door gauge on every visit, included as standard, and a clean site when we leave.
As an independent CertainTeed service provider, we read CertainTeed product literature closely, but we are not affiliated with or authorized by CertainTeed – and we will tell you plainly when a CertainTeed product is the right answer versus when a different material is. Materials are sourced from CertainTeed, Owens Corning, Johns Manville, Knauf, Rockwool, Icynene, Demilec, and GreenFiber, so there is no proprietary lock-in steering the recommendation.
What CertainTeed Spray Foam Insulation Costs in Boulder City
Boulder City homes tend to sit on larger lots with big attic footprints and deep garages, so square footage drives cost more than complexity here. The ranges below are what we typically quote; the written price on your job is exact and arrives before a crew is scheduled.
| CertainTeed scenario | Typical range |
|---|---|
| Rim joist closed-cell foam, 2 inches, 100 linear feet | $1,100 – $1,900 |
| Attic floor open-cell foam over CertainTeed membrane, 1,500 sq ft | $2,400 – $3,600 |
| Full attic air sealing plus open-cell foam, 2,000 sq ft | $3,200 – $4,800 |
| Garage ceiling closed-cell foam, 500 sq ft | $1,600 – $2,600 |
| Roof deck closed-cell foam, per board foot | $1.20 – $1.90 |
| Blower-door test before and after, documented | Included |
What moves the price: foam type (closed-cell runs roughly three times the material cost of open-cell per inch), whether existing CertainTeed batts or membrane need removal first, and whether the roof deck is vaulted. If you have a competing written estimate, bring it in – our second opinion is free and we will read it with you line by line. Call (844) 320-7926 for a free estimate.
Why Boulder City Homeowners Call Envelope Insulation Boulder City for CertainTeed Work

Our technicians have up to 10 years of experience, and they have pulled compressed CertainTeed batts and re-sealed failed MemBrain seams in enough Boulder City attics to know the failure modes by sight. Every completed job carries the 365-Day Done Right Promise – if it is not done right, we make it right – backed by the written scope and written warranty you received before anyone lifted a tool. Calls are answered by a live person 24/7, so you are not leaving a voicemail at 9 p.m. on a Tuesday. And when a CertainTeed product is not the right material for a cavity, we say so and quote the alternative; we also service Reflectix radiant barrier products if that is what your envelope already has.
FAQs
It depends on the product and the assembly, not the foam itself. CertainTeed’s written warranty language is what governs, and the common failure is not the material but foam applied over wet substrate or in a way that traps moisture against it. We read the warranty document with you before quoting so the fix does not put a covered product at risk.
Most failed CertainTeed-adjacent foam jobs we see in Boulder City can be cut back to sound material and re-sprayed rather than fully removed – bad bond lines and untreated penetrations are localized. Full removal only happens when the foam was sprayed over wet sheathing or the wrong foam type was used in a wet assembly. The blower-door reading tells us which one you have.
Most residential jobs are scheduled within a few business days, and a single rim joist or penetration job can often be handled same day. A live person answers (844) 320-7926 around the clock, so you get a real answer about timing rather than a callback window.
Yes, on every job where the assembly allows. You get a before-and-after CFM50 reading on the job record, so the performance change is a number you can look at rather than a claim you have to take on faith.
We source CertainTeed, Icynene, Demilec, and the other brands on a per-job basis rather than holding inventory – which means the foam on your job is fresh and mixed to the manufacturer’s specification on the day, not sitting on a shelf. That matters more than it sounds like it should for a product with a shelf life.
Written by the team at Envelope Insulation Boulder City, serving Boulder City and nearby areas.