Demilec Spray Foam Insulation in Boulder City: What to Know First
We install Demilec spray foam insulation in Boulder City as an independent Demilec service provider, and most residential jobs here are completed in one to two days. You’ll get a written price before any work starts and, where the job calls for it, before-and-after blower-door numbers so you can see the change in one figure. This page is for Boulder City homeowners who already have a Demilec spec in hand – Heatlok HFO, Heatlok Soy 200, Soya or SEALECTION – and want it applied right in a desert climate where attic temps swing hard. Call (844) 320-7926 and a live person answers, day or night.
How Demilec Products Fail – and How We Fix Them
Demilec chemistry is solid. What fails is the install, the substrate, or a spec written for a milder climate than Boulder City’s. Here’s what we actually find out here, and what we do about it.
- Heatlok HFO 200 off-ratio in our heat. The most common Demilec problem we see is foam that cures brittle or gummy because the A and B drums went off-ratio – usually a temperature issue in a garage or a failed proportioner, worse when the ambient is above 100°F. We run ratio checks and a test spray before we open a wall, and we cut out and re-shoot any pass that doesn’t set right.
- Soya and Soya-based open-cell shrinking on dry framing. Open-cell Demilec (Soya, SEALECTION 500) is a vapor-permeable product, and in a Boulder City attic that dries out to single-digit humidity, foam sprayed over wet or unseasoned lumber pulls back and leaves gaps at the top plate. We meter moisture in framing first and keep coverage tied to the substrate, not to a flat thickness spec.
- Rim joists sealed without a thermal break. SEALECTION and open-cell sprays on the rim joist alone will sweat at the cavity when the desert drops to 30s overnight. A closed-cell Demilec pass (Heatlok) on the rim, with the band protected, is the fix we spec here.
- Old Heatlok classic formulations on remodels. Homes built between 2015 and 2025 sometimes carry a Demilec spec that was written to an earlier code cycle, and it may not clear current ignition-barrier requirements under Boulder City’s adopted building code. We read the permit and the spec together before we spray, so what we put in passes inspection the first time.
- Garage ceiling and roof-deck jobs sprayed without drainage detailing. A closed-cell Demilec roof deck can trap a leak if the deck isn’t prepped. We document roof condition, airflow and any existing moisture with photos before we close it in.
Our Demilec Spray Foam Insulation Process

- 1
Call and walkthrough. We schedule a site visit, and a background-checked technician shows up on time with a text when they’re on the way. We measure the space, inspect the substrate, and photograph what we see.
- 2
Written price and scope. Before anyone lifts a tool, you get a written price, a written scope, and the warranty language – Haven Standard Clause 1. No surprises after.
- 3
Diagnostics. Where the job warrants, we run a blower-door test – a pressurization reading that shows, in a single number, how much air your envelope was losing – and we seal top plates, can lights and penetrations first. In that order.
- 4
Parts decision. OEM Demilec drums and quality aftermarket equivalents both get read against the spec and the warranty. On a warranty-critical job, we keep the OEM product; on a non-warranty retrofit, we’ll quote both so you can see the delta in dollars.
- 5
The spray and the seal. We run ratio checks, test-spray, then apply. Closed-cell and open-cell passes are scheduled around the day’s temperature – we don’t spray an attic at 4 pm in July in Boulder City because we won’t get the cure we want.
- 6
Test, document, and close. A post-job blower-door reading on applicable jobs, a Documented Photo Record on every visit, and a closeout before we leave. Backed by the 365-Day Done Right Promise.
What Demilec Spray Foam Insulation Costs in Boulder City
Here are real ranges for Demilec spray foam work in Boulder City. Every job is priced in writing before work starts, and a competing written estimate gets a free second opinion from us.
| Scenario | Typical range |
|---|---|
| Attic floor, open-cell Demilec (Soya, SEALECTION), ~1,200 sq ft | $2,400 – $3,900 |
| Attic floor, closed-cell Demilec (Heatlok), same footprint | $3,600 – $5,900 |
| Rim joist package with closed-cell Demilec | $1,100 – $2,200 |
| Garage ceiling, closed-cell Demilec | $1,800 – $3,400 |
| Roof deck, closed-cell Demilec | $4,500 – $8,500 |
| Attic air sealing package before spray (top plates, can lights, penetrations) | $900 – $1,800 |
What moves the number: substrate prep, cure-time demands in extreme heat, ignition-barrier finish, and whether the job needs air sealing first. Call (844) 320-7926 for a free estimate with a written price.
Why Boulder City Homeowners Call Envelope Insulation Boulder City for Demilec Work

We’ve sealed and insulated 9,000+ homes since 2016 – and every one got a written price before work started and a documented record when we left. Our technicians have up to 10 years of experience, and they read a Demilec spec the way the manufacturer intended – ratio, substrate, climate, code – not the way it was scribbled on a bid. If you have a Demilec estimate in hand, we’ll read it with you under the Free Second Opinion. And we’re not a one-brand shop – Reflectix and other products come up too, and we quote what fits your envelope. 365-Day Done Right Promise on all completed work. Calls answered by a live person, 24/7.
FAQs
Yes – Demilec’s own product warranty applies to the foam itself, and our 365-Day Done Right Promise covers our workmanship on top of it. If something we installed isn’t right within that year, we make it right. Call (844) 320-7926 for a free estimate and we’ll walk you through the written warranty before any work starts.
We quote both when the spec allows it, and we keep to OEM Demilec chemistry on any job where the homeowner’s warranty rides on it. On a non-warranty retrofit, the aftermarket equivalent can save real money – usually 10-18% on the material line – and we show you the delta in the written price. Call for a free second opinion if you already have a Demilec quote.
Most Demilec repairs don’t need a full tear-out. Off-ratio patches, pull-back at top plates, and rim joist failures are typically cut out and re-shot for a fraction of a full replacement. We’ll tell you honestly which one you’re looking at after a walkthrough. Call (844) 320-7926 for a free estimate.
Most residential Demilec jobs in Boulder City get a site visit within a few business days, and material lead time is typically 3-7 days depending on the Demilec series and whether we’re pulling OEM or aftermarket. Call (844) 320-7926 – a live person answers and can schedule your visit.
Always. Under the Haven Standard, air sealing of top plates, can lights and penetrations happens before any insulation, including Demilec spray foam – we won’t blow or spray over an unsealed attic floor. That’s the reason our blower-door numbers show real change, not cosmetic numbers. Call (844) 320-7926 for a free estimate.
Get a Written Price on Your Demilec Job

If you have a Demilec spec, a competing bid, or just a hunch your attic is losing air, call (844) 320-7926. A live person answers, 24/7. We’ll schedule a walkthrough, show you what we find, and hand you a written price before anyone lifts a tool. Free second opinion on any written estimate. Documented Photo Record on every visit. 365-Day Done Right Promise on all work.
Written by the team at Envelope Insulation Boulder City, serving Boulder City and nearby areas.