Icynene Home Energy Audit in Boulder City: What to Know First
An Icynene home energy audit in Boulder City typically runs $390 to $850 and takes two to four hours, including a blower-door test, thermal imaging, insulation inspection, and a duct leakage test. We’re an independent Icynene service provider, not affiliated with or authorized by the manufacturer, so we audit what your home is actually doing rather than what a product label promises. You get a written report with before readings, documented photos, and a flat written price for any work before anyone lifts a tool. If you’ve had Icynene spray foam in your attic, walls, or crawl space and your energy bills don’t match the sales pitch, this page is for you. Call (844) 320-7926.
How Icynene Products Fail – and How We Fix Them
Icynene is a spray foam family, and spray foam fails differently than fiberglass batts or blown cellulose. It doesn’t sag or settle; it shrinks, pulls away, gets installed wrong, or hides a problem underneath. In Boulder City’s climate, with summer highs routinely past 105°F and very low humidity, the failure modes we find are consistent. Here are the five we see most on audit calls.
- Icynene Classic and Classic Plus shrinking at the framing edges. Older open-cell Classic foam can pull back from top plates and stud bays as it cures, leaving a thin gap that reads like a sealed assembly but leaks air. The blower door finds it. We seal the perimeter with a compatible foam and re-test.
- Icynene ProSeal applied too thin on the attic floor. ProSeal is medium-density closed-cell and only performs at the labeled thickness. When it’s sprayed at half depth to hit a budget, the R-value isn’t there and the vapor barrier isn’t either. Our thermal imaging shows the thin zones in a single pass, and we spec the correct depth in writing.
- Icynene MD-R-200 underneath a hot roof deck with no air barrier at the penetrations. The foam itself is fine; the can lights, plumbing chases, and top plates around it were never sealed. Boulder City attics get driven hard in July and August, and those gaps pull conditioned air out of the house all afternoon. We air-seal the penetrations first, then verify with a second blower-door reading.
- Icynene Classic Plus over a wet substrate. Closed-cell foam sprayed on damp sheathing or framing traps moisture and delaminates. The symptom is a soft, hollow sound when you tap the foam and a musty smell near the roofline. The audit confirms it with a moisture meter and thermal scan; the fix is removal and re-spray once the assembly dries.
- Icynene in a crawl space installed over an unsealed vapor barrier. Boulder City crawl spaces rarely see bulk water, but the soil gas and humidity differential is real. Foam on the underside of the floor with a torn or missing ground barrier defeats the assembly. We re-seal the barrier and check the foam for voids.
Our Icynene Home Energy Audit Process

- 1
Phone call and scheduling. A live person answers 24/7 and books a window, not a callback range measured in business days. Under Haven Standard: Arrive on schedule, you get a named technician and a text when they’re on the way.
- 2
Blower-door test. We pressurize the house to 50 pascals and record the CFM50 reading – a single number that shows how much air your envelope is losing. That’s your before figure, documented.
- 3
Thermal imaging and insulation inspection. An infrared camera walks the ceiling plane, wall cavities, and crawl space while the house is under pressure. Thin Icynene, missing foam, and unsealed penetrations all show up as temperature anomalies.
- 4
Duct leakage test. We measure duct leakage separately so you know whether the loss is the envelope or the duct system – they’re different problems with different fixes.
- 5
Written report and written price. You get the photos, the readings, and a flat written price for any recommended work before anyone touches your home. If you have a competing estimate, bring it – we’ll read it with you at no charge.
- 6
Re-test after repair. On applicable jobs, we run the blower door again and publish the after reading next to the before, so the result you paid for is a number, not a feeling.
Our technicians have up to 10 years of experience on spray foam and envelope work, and every visit includes a Documented Photo Record – not on request, on every job.
What Icynene Home Energy Audit Costs in Boulder City
Here’s what Boulder City homeowners actually pay for the audit and the most common follow-on work. The audit itself is diagnostic; the repair pricing is separate and always quoted in writing.
| Service | Typical Range |
|---|---|
| Full home energy audit (blower door, thermal imaging, insulation inspection, duct leakage test) | $390 – $850 |
| Blower-door test only (single reading) | $185 – $295 |
| Duct leakage test only | $165 – $275 |
| Attic air sealing at top plates, can lights, and penetrations | $650 – $1,450 |
| Icynene ProSeal re-spray to correct thickness (per 1,000 sq ft of attic floor) | $2,100 – $4,200 |
| Crawl space vapor barrier re-seal | $480 – $1,100 |
What moves the price: square footage, how many penetrations need sealing, whether the existing Icynene has to be removed before re-spray, and whether the duct system needs sealing or replacement. Estimates are free, and the audit price is the audit price – we don’t bait-and-switch it.
Why Boulder City Homeowners Call Envelope Insulation Boulder City for Icynene Work

The audit is the easy part. What separates a good audit from a useless one is what happens after – whether the air sealing actually gets done before anyone sprays foam, and whether you can prove the difference afterward. We won’t blow insulation over an unsealed attic floor, ever. Air sealing is a hard prerequisite on every job, not an upsell.
That’s the Haven Standard, which we’ve operated under since 2016 across more than 9,000 homes: a written price before any work starts, a written scope and written warranty, and a Documented Photo Record on every visit. The 365-Day Done Right Promise covers all completed work – if it’s not done right, we make it right. Our technicians are background-checked and uniformed, and we’re just as comfortable auditing a Reflectix radiant barrier install as we are evaluating Icynene. Bring us a competing estimate and we’ll read it with you at no cost.
FAQs
Yes – a diagnostic blower-door test, thermal scan, or duct leakage test does not alter your Icynene warranty, because nothing is removed or modified. As an independent Icynene service provider, we’re not the warranty holder, but we document the assembly condition in photos and readings so you have a record to bring to the manufacturer if a claim ever comes up. Call (844) 320-7926 for a free estimate.
Yes. We source from Icynene, Demilec, Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, and GreenFiber, so we can match existing Icynene Classic, Classic Plus, ProSeal, and MD-R-200 assemblies with the correct compatible foam rather than a generic substitute. No proprietary product lock-in. Call (844) 320-7926 for a free estimate.
Repair is almost always cheaper when the failure is at the edges, at the penetrations, or in isolated thin zones – typically $650 to $1,450 for attic air sealing versus $2,100 to $4,200 for a full re-spray of a 1,000-square-foot attic floor. Replacement is the right call when the foam is delaminated from a wet substrate or sprayed at half the labeled depth across the whole assembly. The audit tells you which one you have. Call (844) 320-7926 for a free estimate.
We schedule audit windows within a few business days, and urgent calls – active moisture, musty smells near the roofline, or a failed blower-door retest – get routed same-day when capacity allows. A live person answers 24/7, and you get a text when the technician is on the way. Call (844) 320-7926 for a free estimate.
Icynene’s materials tell you the labeled R-value and thickness for each product line. What they can’t tell you is whether your installer actually sprayed ProSeal at spec, whether Classic pulled away from the top plates in your specific attic, or whether your Boulder City home’s can lights and plumbing chases were sealed before the foam went in. The blower-door CFM50 reading and the thermal scan answer those three questions in one visit – that’s the number that tells you whether the assembly is performing. Call (844) 320-7926 for a free estimate.
Written by the team at Envelope Insulation Boulder City, serving Boulder City and nearby areas.