A Topside company - serving Boulder City, NV

Johns Manville Insulation Removal & Replacement in Boulder City, NV

Johns Manville Insulation Removal & Replacement in Boulder City: What to Know First

We remove and replace Johns Manville insulation in Boulder City, and most attic jobs run one to two days from tear-out to final blower-door reading. Pricing is straightforward: attic removal and replacement typically runs $2,200 to $5,400 depending on square footage, contamination level, and whether air sealing is added, and you get a written price before any work starts. We’re an independent insulation contractor, not affiliated with or authorized by Johns Manville, so our recommendations stay tied to what your Boulder City home actually needs, whether that’s Johns Manville, Owens Corning, Knauf, or Rockwool. This page is for owners of Johns Manville batts, blow-in, or spray foam who suspect their insulation is failing.

Call (844) 320-7926

Call (844) 320-7926 for a free estimate and a written scope.

How Johns Manville Products Fail – and How We Fix Them

Johns Manville makes solid products. What fails in Boulder City attics is usually installation, moisture, or the material aging against 100°F-plus summer attic heat. Here are the failures we see most and how we handle each:

  • Compressed or settled fiberglass batts (R-13 to R-30 Kraft-faced lines). Batts installed over a wide attic floor cavity without air sealing get crushed by HVAC techs walking the joists, and blown fiberglass settles over time. The R-value in the middle of the run stays, the R-value at the edges drops sharply. We pull the batts, seal the top plates and penetrations underneath, then reinstall or replace to spec so the number on the label matches what’s in your attic.
  • Kraft or foil facing turned inward and trapping moisture. In Boulder City, facings installed vapor-barrier-side-up over warm attic air drive moisture into the framing. We find the wet run with a moisture meter and thermal imaging, remove the affected batts, and correct the facing orientation on the replacement.
  • Johns Manville spray foam (the Corbond and JM line) that was applied too thin or too cold. Thin passes leave the foam at less than the rated R-value and open to off-gassing. Cold substrate weakens adhesion, and the foam delaminates in sheets. We remove the delaminated sections down to clean deck, then either re-spray to full thickness or switch to a batt-and-blow-in assembly.
  • Contaminated blow-in fiberglass under animal activity. Johns Manville blow-in is vulnerable to raccoon and squirrel nesting in the Boulder City foothill lots, and to rodent burrowing where the vapor barrier is torn. We remove the compromised material to the deck, clean and disinfect, then air-seal and reinstulate.
  • Vermiculite and mixed-age insulation under newer Johns Manville installs. On homes built before 1990, an insulation company added Johns Manville over a pre-existing vermiculite layer. Vermiculite of that era may contain asbestos, so it’s removed as a distinct scope under proper containment before any new material goes down. That’s a real cost difference from a straight removal, and we tell you up front.

Our Johns Manville Insulation Removal & Replacement Process

professional attic insulation service
Our Johns Manville Insulation Removal & Replacement Process
  1. 1
    Diagnose. We measure the existing R-value with a depth probe and thermal camera, run a blower-door test (a pressurization reading, in CFM50, that shows how much air the envelope is losing), and photograph the attic before we touch anything.
  2. 2
    Scope and price. You get a written scope, a written warranty, and a flat price before any work starts, under The Haven Standard Clause 1. Bring us a competing quote and we’ll read it with you.
  3. 3
    Contain and remove. We set up containment and negative air for vermiculite or heavy contamination, then bag and haul out the old Johns Manville material. Every removal gets a Documented Photo Record, including the deck before we cover it.
  4. 4
    Air seal. Top plates, can lights, and every penetration get sealed before any new insulation goes down. We never blow insulation over an unsealed attic floor.
  5. 5
    Replace and test. New Johns Manville or an alternate from Owens Corning, Knauf, or Rockwool goes in to the spec R-value for your Boulder City zone. We re-run the blower-door and publish the before-and-after numbers so you can see what you paid for.
  6. 6
    Close out. Photos, blower-door sheet, and your warranty in hand. The 365-Day Done Right Promise applies.

What Johns Manville Insulation Removal & Replacement Costs in Boulder City

Scenario Typical range
Attic removal + Johns Manville replacement (1,200 – 1,800 sq ft) $2,200 – $3,800
Attic removal + replacement + air sealing (1,800 – 2,500 sq ft) $3,200 – $5,400
Contaminated removal (animal, water damage) + clean + replace $2,800 – $6,200
Vermiculite removal with containment, before replacement $4,500 – $9,500
Spray foam removal (partial, delaminated sections) $1,200 – $4,000

What moves the price: total square footage, R-value target, contamination and vermiculite, HVAC obstructions, and whether air sealing is included. Older homes in Boulder City with knob-and-tube wiring, low headroom, or multiple attic accesses add handling time. Written price before work. Free second opinion on any quote. Call (844) 320-7926 for your exact number.

Why Boulder City Homeowners Call Envelope Insulation Boulder City for Johns Manville Work

Professional technician installing fiberglass batt insulation in an attic
Why Boulder City Homeowners Call Envelope Insulation Boulder City for Johns Manville Work

Two things drive the decision. First, air sealing is treated as a hard prerequisite, not an upsell. We won’t blow Johns Manville over an unsealed attic floor, because the second reading on the blower-door will show the air loss anyway. Second, the numbers are published. Before-and-after CFM50 readings ship with every applicable job, so you can see the change the way a builder would. Our technicians have up to 10 years of experience, calls are answered by a live person 24/7, and every visit ends with a Documented Photo Record. We also work with Reflectix and other brands, so the recommendation reflects your home, not a product we’re pushing. Independently owned and operated under The Haven Standard since 2016.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Does removing Johns Manville insulation void the manufacturer warranty? No. Removing existing Johns Manville insulation does not void any Johns Manville material warranty, because the warranty covers the new product installed, not the removal. What matters is that the new material is installed to spec and documented. We provide the install documentation with every job.

Is Johns Manville insulation available same-week in Boulder City? Yes. Johns Manville batts, blow-in, and foam are stocked in the regional supply chain and usually available within a few business days. If a specific R-value or facing is back-ordered, we can pivot to Owens Corning, Knauf, or Rockwool at the same spec. Call (844) 320-7926 for a current availability read.

Should I repair or replace failing Johns Manville insulation? Replace if more than about 25% of the run is compressed, wet, contaminated, or delaminated. Repair doesn’t help when the R-value itself has dropped. We run a blower-door test and a depth check first, and we tell you which side of that line you’re on before you commit.

How long does a Johns Manville removal and replacement take in Boulder City? Most attic jobs are one to two days. Vermiculite or heavy contamination pushes that to two to four days because of containment and haul-off. You get a written schedule with the written price.

Do you publish the blower-door numbers on Johns Manville jobs? Yes. On every applicable job, we publish the before-and-after CFM50 reading in the closeout document. That’s how you verify the air-sealing work, not just the new R-value. Call (844) 320-7926 for a free estimate.

Get a Written Price on Your Johns Manville Job

Contractor installing fiberglass batt insulation in a residential attic
Get a Written Price on Your Johns Manville Job

If your Johns Manville insulation is failing, the fastest next step is a call. We answer live, 24/7. You’ll get a written scope, a written price, and a written warranty before anyone lifts a tool, plus a free second opinion if you’re comparing quotes. Call Envelope Insulation Boulder City at (844) 320-7926.

Written by the team at Envelope Insulation Boulder City, serving Boulder City and nearby areas.

Need Insulation help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 320-7926
Local Service Coverage

Request a Free Estimate in Boulder City

Tell us what you need - Envelope Insulation Boulder City responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch