Trusted Home Energy Audit for Boulder City Homeowners
If your Boulder City home feels hot upstairs by 2 p.m. and cold again by midnight, the problem is usually the building envelope, not the thermostat. A home energy audit measures where conditioned air is escaping and where heat is coming in, so you fix the actual leaks instead of guessing. Our technicians have up to 10 years of experience running blower-door tests, thermal imaging, and duct leakage checks on homes across Boulder City, and we can often get a diagnostic visit scheduled the same day you call. We’re licensed, insured, and every audit ends with a written report and a Documented Photo Record, not a verbal estimate. Call (844) 320-7926 and a live person will answer, any hour.

What Our Home Energy Audit Service Includes
A home energy audit is a set of measurements, not a walkthrough with a clipboard. Below are the four diagnostics we run on nearly every Boulder City home, and what each one tells us about your house.
Blower Door Test
The blower-door test is a pressurization measurement that shows, in a single number, how much air your building envelope is losing. A fan seals into an exterior doorway and pulls the house to a set pressure while a gauge records the airflow in cubic feet per minute at 50 pascals of pressure (CFM50). Boulder City sits at roughly 2,500 feet with dry desert air and strong afternoon sun, and homes here shed that heat load through gaps you can’t see: recessed can lights, top plates, plumbing penetrations, and attic hatches.
You need this test before any insulation goes in. Blowing insulation over an unsealed attic floor traps the leaks underneath it and hides the problem. We run the blower door before air sealing and again after, so you can see the before-and-after numbers published on your job. That is the whole point of testing: one figure that proves what changed.
Thermal Imaging Inspection
Infrared thermal imaging shows temperature differences across walls, ceilings, and floors, which is how we spot missing insulation, wet spots, and air channels that a visual inspection would miss. We walk the interior and exterior with the camera running, then photograph the frames that show a real problem. In Boulder City, thermal imaging regularly turns up vaulted ceilings with no insulation behind the drywall and sun-facing west walls that read 15 to 20 degrees hotter than the rest of the room.
You need it when one room never matches the rest of the house, when ceilings are finished and we can’t see the cavity, or when a previous insulation job is in question. The images go into your documented record alongside the blower-door readings, so you have evidence of exactly where the envelope is failing.
Insulation Inspection
An insulation inspection measures what’s actually installed against what your home needs, using depth readings and R-value targets adjusted for our climate zone. Most Boulder City homes built in the 1980s and 1990s were insulated to a lower standard than today’s recommendation for Clark County. We check attic depth, wall cavity fill, rim joist coverage, and the condition of the material, including whether rodents have compressed or contaminated it.
You need an inspection if your attic looks patchy, if you’ve had pest activity, or if a previous contractor installed insulation without sealing first and you want an honest read on it. If the insulation is fine and the problem is air leakage, we’ll tell you that instead of selling you batts you don’t need.
Duct Leakage Test
A duct leakage test pressurizes your duct system and measures how much air escapes before it reaches the rooms. In a finished attic, ducts can lose 20 to 30 percent of conditioned air to the space around them, which means you pay to cool the inside of your attic. Boulder City attic temperatures hit 140°F in July, so leaking ducts here are expensive in a way they aren’t in milder climates.
You need this test if certain rooms never get comfortable, if your energy bill climbs while your thermostat setting stays the same, or if you’re planning an insulation upgrade and want to know whether the ducts above are working. We test the system, document the leakage figure, and tell you where the failures are located.
Brands We Service for Home Energy Audit

Insulation is a commodity until you look at how it fails. We work with Owens Corning fiberglass batts and loose-fill, and we know where that material compresses, settles, and loses R-value faster than the label suggests. We also work with Rockwool mineral wool for fire-rated assemblies and rim joists, where the dense fiber holds its shape better against the heat and pest pressure common in Boulder City attics. Where the cavity calls for blown fiberglass, we install GreenFiber.
Rigid and sprayed foam from Johns Manville and Knauf rounds out the envelope work when a cavity needs a seal that batts can’t provide. We source from these brands because the specifications can be checked, and because none of them ties us to a proprietary system. Whether your home has Owens Corning, Johns Manville, Rockwool, or any other make, we can tell you what’s there, whether it’s performing, and what it would take to fix it.

Signs You Need Home Energy Audit Right Now
- Your summer bill jumped without a rate change. A leak in the envelope or a duct failure shows up as a bill that climbs while your habits stay the same. A blower-door reading tells you whether the air loss is the cause, usually within a week.
- Upstairs is hot, downstairs is cold. That split room to room is often missing attic insulation combined with a leaky top plate, not an HVAC sizing problem. Thermal imaging shows which one it is.
- You can feel air moving at outlets and switch plates. Drafty receptacles on exterior walls mean the wall cavity is connected to the outside without a seal. In Boulder City that’s a two-way leak: hot air in during the day, cool air out at night.
- Dust collects on the same surfaces every week. Particulates pulled through attic penetrations land where the leaks are. A duct and envelope diagnostic finds the source instead of the symptom.
- You’re planning insulation or a new HVAC unit. Adding either without a baseline test means you won’t know if the money worked. Get the numbers first, so the before-and-after is documented.
Our Home Energy Audit Process – Step by Step

- 1
Written price before any work starts. Haven Standard Clause 1 is flat: you get a written scope, a written price, and a written warranty before anyone lifts a tool. No on-site surprises, no price that depends on what we find.
- 2
Blower-door baseline and thermal walk. We set up the blower door, record the CFM50 reading, and run thermal imaging through the interior and exterior. Photos of each problem area go into your file. This is your starting measurement, the number everything else gets compared to.
- 3
Insulation and duct inspection. We check attic depth, wall fill, rim joists, and duct connections, then test the ducts under pressure. You get a leakage figure in the same report as the envelope number, so both gaps are on the page together.
- 4
Written findings and photos. We sit down with the readings, the thermal images, and a written explanation of what each one means. If the fix is air sealing and a top-off of insulation, we say so and write it up. If something else is the driver, we say that too.
- 5
Documented photo record on every visit. When the work is done, you get the closing blower-door reading next to the opening one, plus the photo record of what we found and what we did. If it’s not done right, the 365-Day Done Right Promise means we make it right.
How Much Does Home Energy Audit Cost in Boulder City?
A blower-door test and thermal scan for a typical Boulder City single-family home runs $300 to $550 depending on size, number of stories, and whether the attic is accessible for a full inspection. Adding a duct leakage test usually runs another $150 to $300. On homes over 3,000 square feet or with complex rooflines, expect the upper end of that range. A combined audit that covers envelope, insulation, and ducts is typically $450 to $850, and the report is usable as a baseline for the work that follows.
What moves the price: home size and ceiling height, how many penetrations we need to inspect, whether the attic has a working access, and whether the duct system is in conditioned or unconditioned space. If you’ve already received a written estimate from another contractor, bring it to us for a free second opinion, and we’ll read it with you line by line. Every audit starts with a written price before any work starts, so you’ll know the number before we set up equipment. What’s included: the written scope, the blower-door readings before and after (where required), thermal images, and a Documented Photo Record.
Home Energy Audit Near Boulder City – Our Service Area

We run home energy audits across the Boulder City area and into the surrounding valley, including Henderson, Whitney, Paradise, and Enterprise, with response times of about a day for most scheduled visits. Homes in Whitney and Henderson often share the same envelope problems we see in Boulder City, so the diagnostics travel well. If you’re comparing options, our Home Energy Audit in Henderson page covers that market in more detail. For a broader look at how the audit fits into the full envelope service, start with our home energy audit overview.
Serving Boulder City, NV – Our Local Coverage Area
We serve Boulder City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Home Energy Audit in Boulder City

A home energy audit is a set of measurements that finds where your home loses and gains heat, usually including a blower-door test, thermal imaging, an insulation inspection, and a duct leakage test. It produces numbers you can compare before and after work, not just a list of recommendations. We run the audit and publish the readings so you can see what changed. Call (844) 320-7926 to schedule one in Boulder City.
Most Boulder City homes take two to three hours for a full audit with blower door, thermal imaging, and duct testing. Smaller homes with simple attics can run closer to 90 minutes. Larger homes or ones with complex rooflines and multiple HVAC zones take longer, and we’ll tell you the expected window when we confirm the appointment. Estimates are free, and the visit itself gets a written price up front.
A blower-door test and thermal scan typically runs $300 to $550, and a combined audit covering envelope, insulation, and ducts is usually $450 to $850. Duct testing alone adds $150 to $300. The final price depends on home size, attic access, and how many systems we test. Call (844) 320-7926 for an exact figure, and remember the written price comes before any work starts.
Yes. We work with Owens Corning fiberglass and Rockwool mineral wool, along with Johns Manville, Knauf, and GreenFiber, and we can inspect any of them during the audit. We’re not locked into a single manufacturer, so the recommendation is based on what the cavity needs. Whether your home has one of these brands or any other, we can help. Call (844) 320-7926 and we’ll set up a visit.
We can often schedule a same-day diagnostic visit in Boulder City depending on the day’s routing, and a live person answers the phone 24/7 to confirm. If your issue is a suspected duct failure or a sudden energy bill spike, tell the person on the phone and we’ll prioritize accordingly. No voicemail loops, no callback windows measured in business days. Call (844) 320-7926 to check availability.
If the work isn’t done right, we make it right within 365 days of completion, and it’s backed by the written scope and written warranty you receive before anyone starts. That applies to the audit findings we act on, the air sealing, and the insulation work. The documentation includes the closing blower-door reading and the photo record. Call (844) 320-7926 if you want to read the promise in writing before you book.
Clear the path to your attic access, and make sure the space around your exterior doors is open so we can fit the blower-door frame. Close all windows and doors the morning of the visit, and turn off any whole-house fans. If you’ve had recent pest work or a prior insulation job, have the paperwork handy. Call (844) 320-7926 with any questions before the appointment, and we’ll walk through it.
Schedule Your Home Energy Audit Service in Boulder City Today
Get the numbers before you spend money on insulation or a new HVAC unit. Call (844) 320-7926 for a free estimate, and we’ll schedule a blower-door test, thermal imaging, and duct diagnostic for your Boulder City home. You’ll leave with a written price before any work starts, a Documented Photo Record, and a reading you can compare against later. Live person answers, any hour. Related services we can handle after the audit include attic air sealing and Home Energy Audit in Whitney for neighboring homeowners.
Written by the team at Envelope Insulation Co.